400x34 x 25mm Brush Lined Edge Slot

Cable Management Slots for Furniture are just one element of our Cable Management Range, so if these aren't quite right for you - then Click Here to go through to see our complete range of Desk Grommets, Wire Baskets, Trays and Cable Snakes.

Unlike the mid position slots, these are designed to sit on the edge or to butt up against a vertical surface such as a wall. No need to router a hole, as these units just screw up to form a joint between a vertical and horizontal panel. Supplied with a brush lining, this is the perfect product for discreetly feeding cables, without compromising on aesthetics.

Made from a quality anodised aluminium that has been painted Black, they come with a black brush as standard to give an All-Black finish.

Essentially this component is created from a long piece of extruded aluminium profile, so although we've listed a couple of the most popular sizes for you to buy the part assembled - it is possible for you to buy the extrusion in 1.8 or 2-Metre lengths along with the required end caps, to create your own custom sizes. The individual components are listed below, if you wanted to make up your own custom sizes.

As standard we supply the assembled parts with Black brushes, although Grey brushes are also available to order, subject to moq's. We show standard colours & finishes where possible but these are constantly changing so if you require a colour not listed in the drop-down, speak to us as we may well have added it since.

  There are currently no reviews for this product. Why not submit a review?

Frequently asked questions about this item are shown below. Do you have a question? Submit FAQ

Q: We have two 4m long bench desks with a 70mm channel down the middle. Where there are legs the depth of the channel is 27mm, but otherwise the depth to the cable test is around 120mm. We’re looking for the brushes and extrusion on the back of each desk to cover this channel and wonder if this product will do that ?

A: Hello. Looking at the dimensions you have provided, then this product should fit. However, you will need to consider that the depth of the slot is 25mm, and if we've understood it correctly based on your sizes, this would leave a clearance of just 2mm for cables over the legs? The best thing to do would be to view the dimensions by going to the ‘Technical Data’ tab > ‘Technical Drawing’ and check these against your table dimensions to see if it will fit. Kind regards, BPF

• Technical Drawing
• Technical Drawing - Side Caps
• Dimensional Detail